Archive by Author

BrewPi Case release & instructions

Woohoo, the BrewPi Case is finally here! The latest version is a slightly revised version of our previously posted model and can now be ordered in the BrewPi shop. The kit from the shop can ship in a flat package that fits through a normal mail slot.

All laser cut parts, screws, washers and spacers come with the kit so all you’ll need is a Phillips screwdriver and a few minutes of your time. We made an instruction guide that describes the assembly of the case. It’s pretty straightforward but the steps require a specific order.

As you can see below, the case is fully transparent. After all, why would you want to hide those beautiful geeky bits?

IMG_1008

BrewPi Case!

Hi everyone!

We are ‘Van Alles Wat Ontwerp’, a small design agency, founded by three DIY enthusiasts. Elco asked us to design a case for the Brewing controller as he had his hands full working on the software and electronics.

Apart from beer, we like 3D printers, laser cutters, brewing beer, White Castle, tasting beer, sniffing soldering fumes, bottling beer, working long hours and yet, we still found the time to graduate as Masters of Science.

With this post we would like to propose our case-design to the community. We hope to get some feedback from you so we can improve the case!

Continue Reading →